#Controlspace designer software install

#Controlspace designer software install

Install in accordance with the manufacturer’s instructions. If power is applied and the LED is not illuminated, or if the LED is red, please send the unit for service.Ħ. The POWER indicator LED will illuminate green when the product has mains power. Do not use this apparatus near water or moisture.Ģ0. Heed all warnings – on the product and in the owner’s guide. To completely disconnect the power input, the mains plug of the apparatus shall be disconnected from the mains.ģ. The mains plug is used to disconnect the device and it shall remain readily operable. Keep these instructions – for future reference.ġ9. No naked flame sources, such as lighted candles, should be placed on the apparatus.Ģ. See product enclosure for safety related markings.ġ8. Do not let objects or liquids enter the product – as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock.ġ7. The exclamation point within an equilateral triangle, as marked on the system, is intended to alert the user to the presence of important operating and maintenance instructions in this owner’s guide.ġ6. To prevent risk of fire or electric shock, avoid overloading wall outlets, extension cords, or integral convenience receptacles. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the system enclosure that may be of sufficient magnitude to constitute a risk of electric shock.ġ5. These CAUTION marks are located on the back of the product. Please call Bose to be referred to an authorized service center near you. May expose you to dangerous voltages or other hazards. Important Safety Instructions Caution marks on the product

Perform the firmware update, and then Go Online and Send to Devices.ControlSpace® Engineered Sound Processor Safety Instructions & Install Guide NOTE: When the design is saved during this step, it will be saved (and likely updated) in whichever version of ControlSpace Designer is being used to perform the Retrieve Saved Design action. After retrieving the design, save it to the computer. When executing the Retrieve Saved Design command, ControlSpace Designer will retrieve the existing design from the DSP without trying to go online to the device. In the event that installing the commissioned version of ControlSpace Designer is not possible using the Retrieve Saved Design command in the System menu will allow a copy of the project file to be saved for safe keeping.īefore starting, ensure that project network properties are configured properly for the system in question. In order to determine the version of ControlSpace Designer that created the existing project file, see the article 'Save Retrieved Design to File Using ControlSpace Designer.' In most cases, however, it is best to use the commissioned version of software/firmware to make minor updates to the design file. If the device has older firmware, this may be impossible because ControlSpace Designer may not be able to go online with the device until after the firmware has been updated. Normally, a design can be retrieved from the device by simply going online and using Get from Devices. After loading new firmware, it is always recommended to Go Online and use Send to Devices to ensure that the design file properly matches the firmware. There may also be some cases in which an older design will not run properly with newer firmware.

This is important as a precaution against any problems that might occur during the firmware update, such as a loss of power. Before updating firmware in a ControlSpace device, it is good practice to ensure that any existing design has been pulled from the DSP device and saved on the computer.